12v DC to 220v AC Inverter Circuit

We all face power cuts in our houses or offices some time or another. At those times we generally use Generator or an Inverter. Power generators use petrol or diesel as fuel and they are noisy. We will not be discussing about the power generators here. Here we will be talking about the Inverter. Inverters drive the power from DC power banks, like lead acid battery pack. These inverters are used everywhere now. This type can be used for medium power applications. But for high power appliances Power generators are most preferred one.

The most common type of inverter we see in everyday life is UPS (Uninterruptible Power Supply). We use UPS to keep PC (Personal Computer) running in the event of power cuts. UPS keeps up the power delivered until battery bank runs out.

UPS is a system which converts DC to AC. So, UPS takes DC power of battery as input and gives AC power as output. Today we are going to build a 100 watt 12v DC to 220v AC inverter. This Circuit is simple and very useful.

Required Components:

• +12 v battery
• 47KΩ resistor
• 1000µF capacitor (2 pieces)
• 4700µF capacitor
• 10k pot, 1k resistor (2pieces)
• 10k resistor (2pieces)
• In5408 diodes (2pieces)
• CD4047 IC
• 4.7µF capacitor
• Step down transformer (220v to 12v-0-12v (center tap)) (10Amp)
• IRF540N MOSFET (2pieces)
• Wires

12v-0-12v 10Amp Step down transformer:

IRF540N MOSFET should be used with heat sink, do not use the MOSFET without proper heat sink, without them the MOSFET cannot stand. The MOSFET here is n channel enhancement MOSFET.

Also use some good gauge wire. If you use small gauge wire, you will have losses and under heavy loads they become immensely hot and they will burn out.

Circuit Explanation:

Circuit diagram of 100 watt DC to AC inverter has been given below. We have used EasyEDA to draw this Circuit Diagram, and covered a tutorial on ‘How to use EasyEDA for Drawing and Simulating the circuits’. You can also covert this Circuit Diagram into PCB layout, as we have explained in EasyEDA tutorial, and build this project on PCB.

Working Explanation:

The core of the circuit is CD4047 chip; this chip here acts as an Astable Multivibrator. So the chip generates clock pulses of frequency 50Hz. This frequency is chosen by capacitor C2 and resistor R1. The time period for the signal is given as:

T = 4.71 R1*C2. 

Now to get frequency (1/T) of 50Hz, we need to play with the above numbers. We can choose capacitance as a constant and play with resistance for appropriate frequency. But if you don’t have an oscilloscope to adjust the pot for the exact resistance, choose capacitance as 4.7µF and resistance as 1KΩ. This gives a frequency of 47Hz, which would do just fine for simple loads. If you want to get exact frequency you need to select the resistance accurately.

So the chip generates the clock pulses, these pulses are taken to N-MOSFET to drive the transformer. The transformer steps up the 12V to 230V. So every time a pulse reaches the MOSFET gate, we will have a 220V half cycle at the output. In the next pulse, the second MOSFET triggers for the second half cycle of 220V. So with two MOSFETS turning on and off at 50Hz frequency, we will have 50Hz 220V cycle output at the transformer end.

So we have made a 12V DC to 220V AC Inverter Circuit.